The CBS central power supplysystem is a an advanced, reliable and user-friendly central battery system,designed in compliance with the requirements and all importantstandards. The system provides the possibility of monitoring circuits,luminaires or both.

The CBS central unit is equipped with a controller that supervises theoperation of the entire system and archives all information about the eventsthat have occurred and the system state. It has an intelligent charger thatsupervises the entire battery charging process, which automatically stops thecharging process in the event of a battery failure. Depending on the type offacility, it is possible to connect substations that diversify thefunctionality of the central battery system, and thus reduce installation costsby shortening the length of circuits with installed luminaires. Damage to thecentral unit does not result in a complete system failure, as the substationstake over the control and control of end circuits and luminaires. The SD card usedin the system enables the software update and the recording of the event log.All the above information is additionally stored in the controller'snon-volatile memory. Thanks to the implementation of BACnet Modbus protocols,it is possible to supervise and control the system using BMS devices.

In addition, taking care of the safety of rescue teams, all CBS systems havethe ability to force work in IT mode both from the level of the cabinet and bymeans of an external signal. Taking care of the safety of rescue teams, all CBSsystems have the ability to work in IT mode both from the level of thecabinet and by means of an external signal.

A conventional installation requires that the operating mode of each circuit isspecified as early as at the design stage. Any possible changes or errors mayincur extra costs or even make necessary corrections impossible. In orderto eliminate such inconveniences, AWEX has introduced a new fully automatictechnology to monitor and control each luminaire in a circuit.

The SMART enables installation of luminaires operating in three differentmodes: continuous, intermittent and switched, in a single circuit. Programmingand control of the luminaires is provided by means of power supply cables andtherefore no extra communication cables are required. The SMARTfunctionality is available for luminaires fitted with appropriate addressmodules. The operating modes are set up from the main controller and noadjustments have to be made at the luminaires.

‍